Will a 22 kW generator run my whole Frisco house?

For many Frisco homes, yes. A 22 kW unit covers full HVAC, kitchen, water heater, and daily appliances in a typical home. Add a second HVAC zone or an EV charger and you may need more. A load calculation confirms it.

Can I just use a portable generator instead?

You can, but it works differently. A portable unit requires manual setup and refueling, and it powers only a few circuits. A standby generator starts on its own within seconds and runs on your gas line. If you travel, or if someone at home cannot manage a portable unit, standby is the safer choice.

Does my Frisco home need a panel upgrade for a generator?

Often not. Homes built in the last ten to fifteen years usually have a 200-amp panel already, which handles a standby generator without modification. Older homes with 100-amp service frequently do need an upgrade. We confirm this at the assessment.

What happens if my generator is undersized?

It trips. The unit carries your running load fine, then your air conditioner tries to start, the surge exceeds capacity, and the generator shuts down. You are left without power during the outage you bought the generator to survive.

How long can a standby generator run during an outage?

As long as fuel holds out. Connected to your natural gas line, a standby unit can run for days. Propane units are limited by tank size.

Electrical Panel Replacement in Newman Village, Frisco

Newman Village rose on the Newman family’s 256-acre farm near Eldorado Pkwy and Legacy Dr. The first homes broke ground here in 2008.

We provide electrical panel replacement in Frisco, TX, for Newman Village homes adding backup power. Homes here are newer, so the common question is adding a standby generator. Your panel has to work with the transfer switch, and sometimes it needs replacing first. We’re bringing 50 years of Berkeys expertise to Frisco, starting with a clear look at your panel.

Thinking about a standby generator? Call us before you buy one.

electrical panel replacement newman village - Berkeys Frisco TX

Thinking About a Standby Generator?

Decide what you want running during an outage: the whole home or key circuits.
Check your panel for open spaces.
Call us before you buy a generator, so your panel is part of the plan.

Proudly Serving DFW Since 1975!

Signs Your Panel May Need Work Before a Generator

Even in a newer Newman Village home, the panel can limit how a standby generator gets connected. Use this table to see what common signs may mean and what to do next.

What you notice	What it often points to	What to do
No open spaces in your panel	Your panel is full	Ask us about a replacement
Breakers trip when the AC and kitchen run together	Your panel may be near its limit	Call us to check it
A generator installer said your panel needs changes	Your panel may not fit the setup as-is	Call us to review it
Lights flicker or dim when big appliances start	A heavy load or a loose connection	Call us to check it
The panel feels warm or buzzes	A loose or damaged connection	Call us right away
A burning smell or scorch marks	A serious hazard	Leave the home and call 911

Standby Generators and Your Panel: When a Replacement Comes First

Newman Village homes went up from 2008 on, so panel age is rarely the issue here. Instead, many owners ask about backup power for outages. A standby generator only works as well as the panel it connects to.

How a standby generator connects:

A transfer switch connects the generator to your home’s wiring.
Your panel has to work with that switch and the circuits you choose.

When replacing the panel comes first:

Your panel is full and has no room for the setup.
Your installer finds your panel needs changes for the generator.

We check your panel, replace it if needed, and work with your generator installer. Never plug a generator into a wall outlet. We also arrange entry to Newman Village before work day. You can see all of our electrician services for Frisco homes in one place.

Planning backup power for your home? Call us to check your panel first.

What Happens During a Panel Replacement

Here’s what to expect when we replace the panel in your Newman Village home:

We check your panel and the generator setup you’re planning. Then we explain what we find.
We give you a written plan and price. We time the work with your generator install.
We replace the panel and test your circuits. We confirm everything works before we leave.
We handle the City of Frisco permit and inspection. We take care of it whenever your project needs one.

Serving Newman Village

Newman Village sits near Eldorado Pkwy and Legacy Dr, close to the Dallas North Tollway. Its grand boulevard runs along Newman Blvd, with walking trails and a clubhouse that shares the Newman family’s history. PGA Frisco, The Star and Fields West are all nearby.

Our Frisco location on Avon Ln shares your 75033 ZIP. Ready to get your panel set for a standby generator? Call (214) 216-1727 to reach our Frisco team.

Business Address: 4645 Avon Ln, Suite 260, Frisco, TX 75033